New Garage Door Installation
Insulated steel, carriage-style and windowed doors measured and installed with new tracks, springs and weatherseal.
A new garage door is installed as a complete system, with sections, hinges, tracks, springs, cables and seals sized to the opening and balanced at the half-open point. We begin with the opening: width, height, headroom, side room and backroom decide which track style and spring system will fit. Clopay notes that low-headroom tracks exist for garages with limited overhead space, and that insulated panels use polystyrene or polyurethane to improve energy efficiency and reduce noise.
The material is the next decision. Steel is strong and low maintenance, wood is warm but needs more upkeep, aluminum resists rust and glass panels bring in light. For a house with more than one bay, we order the doors as a set so the color, the pattern and the finish match across the front. Installation follows the manufacturer's documents, and DASMA's checklist for inspectors covers the points we confirm: sound spring anchoring, secure tracks, warning labels, a manual release and a tested reversal if there is an opener.
When a New Door Beats Another Repair
- Several sections are dented, cracked or delaminated
- The door is out of production and no matching section exists
- Repairs keep piling up on an aging door
- Wood sections have swollen, split or rotted
- The garage is hot, loud or leaky around an uninsulated door
- An HOA or a remodel calls for a new look on the street side
🔥 The North Texas Heat & Hail Factor
Heat and storms decide the choices here. The National Weather Service reports consistent 90-degree afternoons in July and August and often 100 or more, so an insulated door is worth a look when the garage shares a wall or a floor with living space. It also describes large hail nearly every year across the Metroplex, which is a reason to order doors of the same model across all bays: a later hail repair is far easier when one section can replace one section. Many neighborhoods also have design review, so we put the model, color and hardware in a written spec that goes to the association before the door is ordered.
How Each Visit Works
Measure the opening
Width, height, headroom, side room and backroom are measured, and the old door and tracks are inspected.
Choose and quote
You pick the material, pattern and insulation, and approve one exact price on site before anything is ordered.
Remove and install
The old door comes out, and the new sections, tracks, springs, cables and seals go in to the manufacturer's instructions.
Balance and test
The door is balanced at half open, the opener is connected, and the reversal and photo-eyes are tested before we leave.